Project64

From OoT Randomizer Wiki
Revision as of 13:31, 6 December 2018 by TreZc0 (talk | contribs)

Project64 Setup for OoT Randomizer

by Tyrus

Template:TOC  

Download: https://www.pj64-emu.com/

To get rid of the donate box that you have to wait 30 seconds for, click ‘Enter notification code’ and type “thank you from project64”.


You will have to follow these steps for every new ROM you use!

Step 1:

Open the ROM. You will get this error message:
 RTENOTITLE
Click ‘Ok’ and *another* error message will pop up:
 RTENOTITLE
Click ‘Ok’ once more, and then press ctrl + t
This menu will pop up:
PJ64 3.png

Untick ‘Hide advanced settings’
Then click on the ‘Advanced’ menu that just showed up.
PJ64 4.png

Tick ‘Remember selected cheats’ because PJ64 needs gameshark cheat codes to run properly.


Step 2:

Click ‘Config: THE LEGEND OF ZELDA’
If it’s not there, load up the ROM and look again.
RTENOTITLE

Where it says ‘Memory size’ go ahead and change that to 8mb, then click ‘apply’ and ‘OK’


Step 3:

PJ64 6.pngPress ctrl + c and then click on the bar on the right of this window
In the box below ‘Code: <address>’ paste : 801DA5CB 0002
And name it something like ‘subscreen delay fix’ (The name doesn’t matter)
PJ64 7.png

Then click ‘Add cheat’ and it should appear on the left.
Tick the cheat, then close out of that menu.

PJ64 8.png
 

Step 4 (Optional but recommended):

Press ctrl + t and click ‘Plugins’ and change the Video (graphics) plugin to ‘Glide64 for PJ64’
Click ‘Apply’ and then ‘OK’.

RTENOTITLE
 

Step 5:

Once you have completed these steps, restart Project64 and open up your ROM.


Step 6:

Click ‘Options’ and ‘Configure controller plugin’

RTENOTITLE
 
Here is where you setup your controller binds.


For xbox controller users:
* In ‘Controller Pak’, untick ‘RawData’, and in the drop down menu, select ‘MemPak’.
* Tick ‘XInput’, and your binds menu will look like this:
The ‘XControls’ correspond to the buttons on your controller, and ‘N64’ is what they will be bound to in-game.

RTENOTITLE
For keyboard users-
* I recommend setting Analogue stick range to 100%, and in ‘Devices’, set ‘Gamepad Deadzone’ to 5%.
* These settings will make it easier to aim.


For users of any other controller-
* My only recommendation is to check out the multitude of other guides on the Internet.


If you want to use a mouse, for some reason, tick ‘N64 Mouse’.


ADDITIONAL HOTKEYS:
Toggle limit fps (fast forward): f4
Toggle pause: f2
Save State: f5
Load State: f7


IF YOU HAVE ANY FURTHER ISSUES, ASK IN THE DISCORD!